Spares: 1967 Ford Cortina GT

• O2 sensor
• Water pumps
• Valve springs
• Thermostats
• Carb floats
• 3 distributors
• Testing motor with 140 HP and 6 bolt stock crank (7000 Max RPM)
• 2 new front brake rotors
• 1 new rear brake rotor
• 2 new Tilton clutch discs
• 1 set Performance Friction front brake pads
• 2 sets Performance Friction rear brake pads
• Font caliper rebuild kit
• 4 steering tie rods
• Front and rear suspension : bearings, seals, spacers, fasteners
• Driveshaft u-joints
• 6 bolt aluminum flywheel and single disc Tilton 7 ¼” clutch
• Windshield wiper arms/blades
• 2 new head gaskets
• Gear reduction starter
• Throttle cables
• Lumenition ignition and rev-limiter
• Water necks and front engine covers
• Water & oil pump drive belts
• Rocker arms, shafts, etc.
• New wide-band O2 sensor
• Stock rear axle housing
• 5 stock 3rd members (3.90 & 4.11)
• Stock flat cylinder head
• Taillights
• Steel bell housing
• Grill
• Stock L & R doors
• Fiberglass: hood, trunk lid, front valence panel/spoiler/splitter

Copyright © Vintage Sports Car Drivers Association. All rights reserved.